Dishwasher - How to replace container cup

Решение

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before any repair or maintenance operation, turn off water supply to the appliance.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE CONTAINER CUP

1. Unscrew the four PH2 screws holding the bottom cover of the dishwasher and then pull the cover towards you to remove.

2. Unscrew the two PH2 screws on the top of the left hand side panel and the three PH2 screws along the back of the left hand panel.

3. Use a small flat bladed screwdriver to prise open the three clips holding the side panel to the appliance, then pull the side panel from back to front to release.

4. Unscrew the ventilation grid anti-clockwise to release it.

NOTE: Ensure that the ventilation grid is tightly screwed back into place during reinstallation

5. Pull the container cup towards you and then up to release the container cup from the salt pot.

Use pliers to squeeze the jubilee clip and slide the clip to down the hose, to release the container.

NOTE: This will release the water from the container cup, it is recommended to put something underneath to catch any residual water. Ensure all seals on the salt pot and the container cup are properly in place during reinstallation.

6. If necessary remove the seal from the container cup.

7. When assembling, repeat steps in reverse order.